User guide

Cleaning Filters
Cleaning Robot
● Turn the Robot OFF by pressing the Button on the LCD.
● The Robot may be cleaned by using a soft damp cloth with a mild soap
solution. The cloth MUST NOT be wet, but wrung dry.
● Do NOT try to extend the Robot to wipe the tower panels.
10. Maintenance of Robot Air Purifier
Anti-bacterial filter layer
Formaldehyde filter layer
Efficient filter layer
#3 Filters particles down to 0.6 Microns
#2 Filters VOC's from the air
#1 Filters down to 0.3 Microns
● Remove the Robot from the Charger Dock and press the OFF button.
● Remove the Top and remove the three filters from the Robot.
● The Top #1 and Bottom #3 filters can be gently tapped on the edge of your
wastebasket to remove any debris.
● You may use the hose attachment of your Vacuum cleaner to suck the fines
out of the filter. DO NOT place the end of the hose or tool directly on the filter
material. This could damage the filter and decrease its efficiency.
● The Middle filter #2, can be gently tapped on the edge of your wastebasket to
remove any debris. DO NOT use a vacuum on this filter as it may cause
damage and render the filter useless.
● After thorough cleaning, install the filters back into the Robot with #3 going in
first, #2 going in on top of #3 and #1 going in on top of #2.
● Replace the Cover making sure it is securely in position.
Efficient Filter
La
yer
COMMENTS:
The #1 and #3 filter may change color after a while. This comes from use. You may check the filters to see if they are
still efficient by holding them up to a bright light and if you can NOT easily see light through the material, it is time
to replace the filters.
The #2 filter should be changed every 6 months or when found that odor filtration is not working well.
Cleaning Drop Sensors
Drop Sensors are located on the bottom of the Robot. Dirty lenses will not allow the
sensors to function properly and may cause the Robot NOT to detect a drop off or
stairs.
● Turn the Robot over onto a flat soft surface.
● You will see five (5) sensors which detect a drop off of more than 1.5 inches.
● These sensors need to be wiped every two weeks or oftener with a soft dry cloth
to remove any dust that has been attracted to the lenses.
22
●
● Using a damp soft cloth, one that has been wrung dry of water, you may wipe the
plug, power supply cord and the Charger Dock.
● Be sure to wipe the sensors with a soft dry cloth before placing back into position
and plugging the power supply cord in to the receptacle.
Unplug the Charger Dock from the Wall.
Cleaning the Charger Dock