User guide

21
Enjoy Smarter Life!
●
● T
●
●
●
●
●
●
Before removing the SD card, you must turn the Robot OFF by the switch on
the bottom of the Robot.
The SD card will become very HO to the touch if removed after using the
Robot, so be very careful in handling the SD card so you do not burn
yourself.
Install the SD card to your computer or to an adapter connected to your
computer.
Go to www.ecovacs.com and click on A330 for your language preference.
Follow the instructions for loading the music to the web site and then to your
SD card.
Reinstall the SD card the proper way and close the cover.
Turn the Robot over and press the switch to turn the Robot ON.
With your Remote, you may select the desired song to play.
Referring to the picture, you may adjust the volume.
●
●
●
●
●
●
●
With all programing having been completed, you are now ready to use the Air
Purifier.
Having placed the Charger Dock in a room where you want the Robot to
operate, place the Robot in the Charger Dock.
With the Robot turned ON, the Robot should automatically go to the Pause
Mode and wait for the next scheduled air cleaning time.
Should no lights light up on the Robot, remove the Robot, turn the Robot over
and press the switch to the ON setting.
Place the Robot back in the Charger Dock and the Robot is ready to go out on
the next scheduled air cleaning.
Remember, the Auto mode is the only mode the Robot will automatically leave
the Charger Dock.
Remember, we strongly recommend that you be present for the first run of the
Robot to make sure obstructions such as cords, magazines, etc. are removed
and the Robot will easily find its Charger Dock when it is time to charge its
battery.
2.0GB
Loc k
Open the Cover
2.0GB
Lock
Insert with Facing up
Volume
Control
Volume
Control
● NOT
● The Magnetic Tape must be applied to a clean dry hard floor surface for proper adhesion.
● After applying the Magnetic Tape, rub the Magnetic Tape with the Magnetism Recovery Tool. This increases the
magnetism of the tape.
● The tape should NOT be used within 5 feet of the Charger Dock as it will interfere with the Robot finding and entering
the Charger Dock.
● The Magnetism Recovery Tool should be used to restore the magnetism of the tape when it is found to be weak.
● There may be residue when you remove the Magnetic Tape. Usually a soapy cloth will clean the area.
● Remaining Magnetic Tape must be stored in a cool, dark place.
● The Magnetic Tape should NEVER be used to confine an
elevated area where the Robot could fall down and hurt a
person or cause considerable damage to the room below
when the tape has lost its magnetism power.
● Instead, attach a permanent guard rail to block the unit
from reaching the edge of the drop off.
Do NOT apply to a carpeted surface as the adhesion will be adequate to keep the magnetic tape in position.
NO
Guardrail
NO
Guardrail
8. Using Robot
9. SD Card
Set up
Guardrail