User guide

18
● Under normal conditions, the Robot will clean the air until the air is clean or the battery
runs low and the Robot needs to return to its Charger Dock to recharge the battery.
● If a longer duration is required to clean the air, the Charger Dock may be moved to the
room and with the provided Charging Cable, connect the Robot to the Charger Dock.
This will allow the Robot to run continuously till the air is clean.
● Do NOT place the Robot under a table or chair as it will decrease the Robot's ability to
cleanse the air.
Spot Mode
Search Mode
● Use of this Mode is desired when known air pollution exists and you desire it to go to the
source to clean the air.
● This Mode is used when you want to clean the air in a particular area because of
various reasons, such as: food preparation in the kitchen, people gathering in a room,
people smoking in a room, pet odors, and other strong or offensive odors. You use the
Remote to direct the Robot to the Spot desired.
● When Robot runs in this Mode, the Robot will travel to find the source of polluted air. If there is
an obstacle in its way, the bumper will activate on touching the obstacle and the Robot will
change direction.
● Having found the source of the pollution, the Robot will stop, the light on top will turn from Green
to RED, the top will extend upwards and the fan will begin to circulate the air through the filters
thus beginning to perform the air cleaning process.
● The Robot can operate for up to 2 hours in cleaning the air.
● When the air has been cleaned, the light on top will turn GREEN, the top of the Robot will retract
and the Robot will move to see if there is Dirty air elsewhere in the room..
● When the Robot detects the battery is running low, it will stop cleaning the air and return to the
Charger Dock for recharging the battery.
Note:
For the unit to clean the air on the next scheduled time, the unit MUST be set back to the AUTO mode and placed back
into the Charger Dock.
Remote
LCD PANEL
Remote
LCD PANEL
SD
Power
Supply
Charging Slot