User guide

Assembling Charger Dock
4. Charger Dock
Remove the Charger Base and Transmitter frame from the carton. Looking at the pictures, connect the
wire from the base to the frame and then carefully insert the frame, keeping the wires from being pinched,
until you hear a "click" sound. This "click" sound indicates the frame is securely latched into the base.
Please check by gently grasping the frame and the back and trying to pull upwards.
Transmitter Frame
Charger Base
Placement of Charger Dock
● Place the Charger Dock against the wall
according to the picture. It must be placed
close to a Receptacle so the Charger Dock's
power supply cord will reach.
● Any excess power supply cord must be bundled and made secure so not to
interfere with the return of the Robot. The power cord may NOT be placed under
the Charger Dock as it will affect the Robot's return to the Charger Dock.
● Please ensure there are NO obstacles within a rectangular box of 5 feet and 1.5
feet on each side of the Charger Dock so the Robot can easily find the Charger
Dock to recharge the battery. A reflective surface, such as mirror, glass, etc.
should NOT be directly opposite the Charger Dock so that it will NOT affect the
infrared signal and keep the Robot from finding the Charger Dock. Do NOT place
close to stairs as it will affect its ability to Dock or even fall down the stairs.
Correct
12
5 fe
e
t
1.5
f
e
e
t
1.
5f
e
e
t