Instruction manual

3. Operating and Programming

3.1 Assemble and Charge

Charging Dock Placement

1.7 feet

5 feet

Place the Charging Dock on a level floor surface with the base perpendicular to the

ground. Keep the immediate area in front of the charger (1.5 m or approx. 5 feet)

clear of objects and reflective surfaces that would interfere with the infrared receiver.

Charge the Robot

Charging indicator light blinks when the robot is charging

Charging normally takes about 3-5 hours

After charging finishes, the charging indicator light stays on.

The robot should be charged at least 12 hours during the first 3 uses.

After the robot’s battery is fully charged, DEEBOT’s battery management system will reduce to a trickle charge

to save electricity.

When the robot is on the Charging Dock, please make sure charging indicator light is blinking or always ON.

Remove batteries if the robot will not be used for a long time.

When the batteries are fully discharged or not used for a long time, their capacity may decrease, so it’s

suggested to reactivate them.

Method of reactivating batteries: place the robot on the Charging Dock by hand, remove after charging for

3 minutes; repeat 3 times, then charge normally for 3-5 hours.

Turn the switch on the bottom of the robot to the ON position.

Place the robot on the Charging Dock making sure the Charging Dock Electrode and the Charging Pin on the

robot make a connection.

Automatic Charging

Three Ways to Charge

The robot can perceive a low

battery when it is working,

and will automatically switch

to Back to Charger mode when

necessary.

You can command the robot

to switch to Back to Charger

mode at any time with the

Remote Control or the button

on the robot’s control panel.

Command Charging Manual Charging

Turn ON the power switch on the

bottom of the robot and place it

on the Charging Dock by hand.

Ensure that the Charging Dock

Electrode and the Charging Pin

on the robot make a connection.

Note

Operating and Programming