Instruction manual

3.3 Mode Selection

The robot has several Cleaning Modes for you to choose from to effectively clean all of your floors.

Automatic Cleaning Mode:

This is the most commonly used mode with the largest cleaning coverage.

In Automatic Cleaning Mode the robot will proceed in a straight line until it comes in contact with an obstacle

and then it will change course in a straight line.

If the DEEBOT detects a lot of dust during its initial route, it will change its path to fan-shaped or spiral route.

Intensive Cleaning Mode: This mode is good for aggressive cleaning, or for extremely dirty or dusty floors.

When the robot works in Intensive Cleaning Mode, it follows the same pattern as

the Automatic Cleaning Mode but performs a more thorough cleaning.

In Intensive Cleaning Mode, the dust sensors sensitivity is increased, so cleaning

is more efficient.

When cleaning a small area like corners or a hallway

in Intensive Cleaning or Automatic Cleaning Mode

cleaning, the robot will automatically conduct a

“zigzag” pattern, then will return to the previous

mode to continue cleaning.

3.2 Power ON/Pause Mode/Power OFF

1. Turn ON the power

switch on the bottom

of the robot.

2. Choose a cleaning mode by

pressing the Mode key on the

robot’s control panel or on the

Remote Control.

Press Start/Pause key to

start the robot.

1. Pause the robot by

pressing any key on the

display or by lifting

the unit off of the floor.

2. Press Start/Pause key

and the robot will resume

work.

After pausing work, turn off the power switch at the bottom of the robot.

Note：When the robot is not working, it’s suggested to keep it charging instead

of power OFF.

Operating and Programming

1.6 feet