Operating Guide

18
EN
6. Troubleshooting
NO.
Malfunction Possible Causes Solutions
5
WINBOT 8 gets
stuck in a corner
or near the edge
of the window, and
cannot be directed
using the Remote
Control.
Not enough suction or Edge
Detection Sensor malfunction.
A. Press the RESET Button on
the Remote Control.
B. If WINBOT 8 does not Reset,
it must be placed in Manual
Override Mode. Hold the RESET
Button on the Remote Control
until the Status Indicator Light
glows a continuous RED. In
Manual Override Mode, the
Direction Control Buttons on the
Remote Control are activated.
Use the Direction Control
Buttons to move WINBOT 8
to a position away from edges
and where you can safely reach
it. Remove the robot from the
window.
*When using the Manual
Override Mode, do not leave the
robot attached to the glass.
C. If the problem persists, please
contact Customer Service.