Operating Guide

13
EN
4. Maintenance
Before performing cleaning and maintenance on WINBOT 8, move the Power Switch to the
“
o
” position and unplug it from the receptacle.
4.1 Cleaning Pad
4.2 Fan and Sensors
Turn the robot over and remove the Cleaning
Pad. Soak the Cleaning Pad in cool, clean
water for 2 minutes. Hand wash with mild
detergent and lay flat to dry. Allow it to dry
completely before re-attaching it to the robot.
Fan
Edge Detection Sensors
Wheel Sensor
Turn the robot over and wipe any debris from
the Fan with the provided Finishing Cloth to
maintain suction.
Turn the robot over and wipe the four Edge
Detection Sensors clean with the provided
Finishing Cloth to maintain their effectiveness.
Turn the robot over and wipe the Wheel
Sensor with the provided Finishing Cloth to
maintain its effectiveness.
Do NOT use a wet Cleaning Pad on
WINBOT 8 or it may slip on the window.
Washing the Cleaning Pad regularly can
extend its service life.
If the Cleaning Pad becomes worn or no
longer ts exactly within the Velcro area,
replace it with a new one to achieve best
cleaning performance.
*
*
*