Users Manual

EN
22
Pre-lter
Dust Sensor
Ensure the appliance is switched off
before cleaning, and remove the dirty
pre-lter from the mesh lter-holder.
Run the appliance in MAX mode, and
rotate the side cover to clean the dirty
pre-lter.
To avoid dust accumulation which can affect
cleaning performance, wipe the suction
mouth with a damp cloth.
Replace a clean lter to the main body. Put
the dirty pre-lter into the cleaning tool and
connect the cleaning tool to the main body.
After cleaning, insert the clean pre-lter into
mesh lter properly and it clicks into place.
Install the clean lters and dustbin back into
the main body, then close the dustbin ap.
①
②
③
④