Users Manual Part 1

No. Malfunction Possible Causes Solutions

When the water in the Cleaning

Tank is full and cannot be sucked

out, the voice reports that the

Cleaning Tank is full.

The Dirty Water Tank is not properly installed. Tap down on the Dirty Water Tank to ensure it is properly installed.

The sealing plugs in the Dirty Water Tank is not

installed properly.

Make sure to check that the sealing plugs are properly installed.

The Station cannot drain water normally.

Double tap

to see whether the Station can properly draw the

water. If the problem occurs during the mopping pads cleaning

process, press and hold

to nish the task, and then double tap

to see whether the Station can properly draw the water. If the

water is successfully drawn, wipe dry the Water Overow Sensor

of the Cleaning Tank. If the Station fails to draw the water, check

between the Dirty Water Tank and the Station for foreign matter

and clean it.

The suction port of the Cleaning Tank is blocked by

foreign object.

Ensure that there is no foreign object in the suction port of the

Cleaning Tank.

The voice prompt still exists after trying the above

solutions.

Unplug the Station and plug it again.If this problem persists,

please contact Customer Care for help.