Users Manual Part 1

including interference that may cause undesired

operation of the device.

RF exposure warning

This equipment complies with FCC radiation

exposure limits set forth for an uncontrolled

environment.

This equipment must be installed and operated

in accordance with provided instructions and

the antenna(s) used for this transmitter must be

installed to provide a separation distance of at

least 20 cm from all persons and must not be

collocated or operating in conjunction with any

other antenna or transmitter.

MPE caution (for mobile device under Part 15.247

& 15.407 device)

To satisfy FCC&ICRF exposure requirements, a

separation distance of 20cm or moreshould be

maintained between the antenna of this device

and persons during device operation.

To ensure compliance, operations at closer than

this distance is not recommended.

To disable Wi-Fi module on DEEBOT, power the

robot ON. Place the robot on the OMNI Station

making sure the Charging Contacts on DEEBOT

and the Station Pins make a connection.

Press and hold the Recall/Exit Button on the

Station for 30 seconds. And press and hold the

AUTO Mode Button on the robot for 30 seconds.

To enable Wi-Fi module on DEEBOT, power the

robot OFF and then power ON. And unplug the

Station and plug it again.

SAVE THESE INSTRUCTIONS

For INDOOR household use ONLY.

To reduce the risk of electric shock, this docking

station has a polarized plug (one blade is wider

than the other). This plug will fit in a polarized

outlet only one way. If the plug does not fit fully in

the outlet, reverse the plug. If it still does not fit,

contact a qualified electrician to install the proper

outlet. Do not change the plug in any way.

This device contains licence-exempt transmitter(s)/

receiver(s) that comply with Innovation, Science

and Economic Development Canada’s licence-

exempt RSS(s). Operation is subject to the

following two conditions:

(1) This device may not cause interference.