User Manual

ManualsBrandsECOTOP ManualsAircraftsFournier RF-4 (White-red)

E E

D D

1) Visser les servos sur leur support. Souder une

prise MG6 (MPX) (#40071310) comme montré aux

rallonges de 150 cm #0434054-150TN.

H Attach the servos onto their support with self-tap-

ping screws. Solder an MG6 (MPX) plug (# 40071310)

as shown to the 150 cm servo extensions # 0434054-

150TN.

2) Remonter les supports servo sur le stab. Rassem-

bler les éléments des guignols de profondeur et décou-

per soigneusement l’entoilage à leur emplacement.

H Reassemble the servo brackets under the stab. Ga-

ther the elements of the elevator control horns and

carefully cut the covering im to their location.

3) Coller les guignols en place, assembler les tringle-

ries de profondeur et les visser, servos et gouvernes

au neutre. Raccorder les rallonges aux servos et assu-

rer à l’aide de sécurités de connecteur #0434085.

H Glue the horns in place, assemble the elevator

pushrods and connect them to the servos and control

surfaces - all in neutral position. Connect the exten-

sions to the servos and ensure using connector safety

locks # 0434085.

EMPENNAGE HORIZONTAL/HORIZONTAL EMPENNAGE

PIECES EMPENNAGE HORIZONTAL

(A) Empennage horizontal .......................................... 1

(B) Carénage bre de verre ......................................... 1

(D) Chape à rotule avec visserie M3x14mm + écrous

nylstop .................................................................. 4 sets

(E) Guignol bre de verre ..................................... 2 sets

(F)

Vis xation stab M4x80mm + colerette alu

....... 2 sets

(G) Vis xation carénage stab 2.5x12mm ................ 2

(H) Taquet bois dur ...................................................... 2

l Servo profondeur TOPMODEL HV48010MG .......... 2

l Rallonge servo torsadée 150cm

(#0434054-150TN)

....... 2

l Sécurité connecteurs

(#0434085)

.................................. 2

H HORIZONTAL TAIL PARTS

(A) Horizontal empennage .......................................... 1

(B) Stab berglass cover .............................................. 1

(D) Ball clevis M3x14mm with screws ............... 4 sets

(E) Fiberglass control horn .................................. 2 sets

(F) Stab screw M4x80mm + alu socket .............. 2 sets

(G) Stab cover screw 2.5x12mm ................................ 2

(H) Hard wood block .................................................... 2

l Elevator servo TOPMODEL HV48010MG ............... 2

Servo extension 150cm twisted wire

(#0434054-150TN)

..... 2

l Extension connector safety lock

(#0434085)

............... 2