Use and Care Manual

AMPERAGE DRAW
THIS TEST IS TO MEASURE AMPERAGE DRAW ON ELEMENT. THIS IS
DONE BY USING THE CLAMP PORTION OF THE METER AND CLAMPING
AROUND THE RED WIRE THAT GOES TO HEATING ELEMENT.
WHILE WATER IS RUNNING GET THE AMPERAGE DRAW FOR ELEMENT.
IT IS IMPORTANT TO FOLLOW THESE STEPS AND WRITE DOWN THE
READINGS/RESULTS.
THESE STEPS WILL ASSIST IN A QUICK RESOLUTION TO ANY ISSUES
YOU MIGHT HAVE WHEN CONTACTING OUR TECHNICAL SUPPORT
DEPARTMENT.
THE LAST PAGE IS DESIGNED TO DOCUMENT ALL READINGS
SHOULD YOU HAVE ANY QUESTIONS BEFORE , DURING OR AFTER IN-
STALLATION YOU CAN CONTACT OUR TECHNICAL SUPPORT DEPARTMENT
TOLL FREE AT 877-474-6473
Email: [e-mail]
Or visit our web site at
www.ecosmartus.com