Full Product Manual

Installation(continued)
Installing the controller cable
□
□
3
Connect the terminal cable from the output of the Inline Controller (B) to the 5-pin end of the light strip.
Plug the 24V DC Plug-in Power Supply (C) into an appropriate 120V power outlet.
Using strip light connectors
□
□
□
4
Locate the cuttable locations on the Strip Light with Adhesive Backing (A), starting from the end that has the
power supply wire attached.
Choose the location to be cut that best suits the length of strip light needed to illuminate the desired area.
Using sharp scissors, cut directly through the center of the cut line. Be sure not to cut off the connection at
the start of the tape.
CAUTION: This LED product is designed to be used only with the 24V DC power adaptor
included with
the kit. Do not operate with any other power supply type. Disconnect power at the source prior to attempting
installation.
B
C
The Strip Light with Adhesive Backing (A) can be cut to a desired length; however, it can only be cut where marked
with vertical line, approximately every 9.8inches. Do not cut eht silver color solder marks; only in the center of the
copper pads as shown. To adjust the length, use the following steps:
9 HOMEDEPOT.COM/Hubspace
Please contact 1-877-592-5233 for further assistance.