Full Product Manual

CAUTION:
To avoid damage to the light strip, do
not twist the light strip or bend past the bend radius
of 60 degrees.
Installation
□
□
□
Layout Considerations
Installing the light strip
Determine the desired location and length of the LED light strip needed for installation. If any cuts are need,
follow "preparing the light strip" below.
Lightly mark the beginning of run where the Inline Controller (B) and Plug-in Power Supply (C) will connect
to the tape. Make sure there is adequate room for the Strip Light with Adhesive Backing (A), Inline Controller
(B), and Plug-in Power Supply (C) in this space and that the Plug-in Power Supply (C) can reach an appropriate
power receptacle without being pulled tightly.
Ensure surface is sturdy and mechanically sound.
□
□
□
1
Clean the location in which the Strip Light with Adhesive Backing (A) is to be mounted to make sure it is free
from dirt, dust, and oil, or anything that will inhibit the adhesive from making solid contact with the mounting
surface.
Peel off the adhesive backing on the Strip Light with Adhesive Backing (A), adn secure the Strip Light with
Adhesive Backing (A) to the desired location by pressing rmly for 30 seconds.
Place the mounting clip (D) over the light strip and secure with mounting screws (E).
Linking the light strip
□
□
2
5x 6.5ft. lengths of light string can be linked together. Do not attempt to connect more than 32.8 ft.
to one power adaptor.
Connect the terminal end from the output of the rst tape light strip to the 5-pin start of the next tape
light strip.
8