Item #1009 525 844 Model #LR411U-2.4X7IR-3M-1024 9.
Table of Contents ................................... 2 Safety Information ................................. 2 Warranty ................................................3 Pre-Installation ......................................4 Installation ........................................5 Operation ..........................................8 Care and Cleaning .............................11 Read and understand this entire manual before you attempt to install or operate this product.
Warranty The manufacturer warrants this fixture to be free from defects in materials and workmanship for a period of two (2) years from date of purchase. This warranty applies only to the original consumer purchaser and only to products used in normal use and service.
Contact the Customer Service Team at 1-800-910-7164 or visit www.HomeDepot.com/EcoSmart.
Prepare the strip light (optional) Shorten the strip light (A) to the desired length by cutting along the black lines.
Install the strip light Ensure that the mounting location is even, clean, and dry. Remove the protective film from the back of the strip light (A). Press the strip light (A) to the mounting surface and hold in place for a few seconds. 3 Install the controller Remove the protective film from the back of the iron sheet(E) Press the iron sheet(E) to the mounting surface and hold in place for a few seconds.
Use the mounting clips(F) to further secure the strip light(A).
Remote Operation CAUTION: The remote control included utilizes a 3V CR2025 battery; Do not dispose of batteries in fire as they may explode or leak. Please dispose of used batteries immediately and safely. Only replace with the same battery type. Examine devices and make sure the battery compartment is correctly secured, e.g. that the screw or other mechanical fastener is tightened. Do not use if compartment is not secure.
Operation(continued) Button Description 1 ON: Press to turn on the light 2 OFF: Press to turn off the light 3 Adjustable brightness: Increase or decrease the 10-level of light brightness 4 Adjustable speed: Increase or decrease the 10-level speed of dynamic mode 5 Fade mode 6 Flash mode 7 Adjustable brightness: 100%, 75%, 50%, 25% 8 Motion mode: * Press MOTION OFF to turn off the motion mode * Press MOON to turn on the motion mode Light turns on in darkness only when get detected Successful
Operation(continued) 2 Controller Operation WARNING: Do not try to replace the lithium polymer battery. The rechargeable battery in controller is not replaceable. NOTE: 1. The controller is rechargeable and detachable. Get the controller fully charged before use it. 2.
Operation(continued) Description 1 IR Remote 2 PIR Motion Receiver 3 Increase the 10-level of light brightness 4 Press to turn on/off the light 5 Decrease the 10-level of light brightness 6 Motion Sensor Mode: [Motion Sun Mode] Light turns on when get detected [Motion Off] [Motion Moon Mode] Light turns on in darkness only when get detected 7 Delay Time Options: Light remains on for 120s, 60s or 15s when not get detected 8 Strip light connection port 9 USB charging port 10 Charging indica
