Instructions / Assembly

Connection Reference 2

Connecting the pigtail cord to the SmartBoost™:

1. The pigtail cord should be partially attached to the unit through the ground connection. With the

cover off, you should see an exposed red wire and black wire coming from the pigtail, on the end

that’s inside the unit.

Connect the red wire to the left-most terminal, and the black wire to the right-adjacent terminal.

2. Tighten the connections on the terminal block with a flathead screwdriver.

MAKE SURE WIRES ARE INSERTED ALL THE WAY IN THE TERMINAL, AND THAT THE SCREWS

SECURING THE CONNECTION ARE TIGHT AND SECURE. FAILURE TO DO THIS WILL CAUSE HEATER

MALFUNCTION. Also, make sure that the wire insulation is not inserted into the terminal block as

this will inhibit a good electrical connection.

3. Replace the unit cover, screws, and control knob.