Full Product Manual

6
Unpairing the LED Bulb
Position the remote (B) within 2 inches of the LED Bulb.
Operation (continued)
□
Energize the power for the LED Bulb and position the remote within 2 inches of the LED Bulb.
□
□
□
□
□
The remote (B) will start to search for the LED bulb (A). The indicator light (AA) will ash rapidly
until the LED Bulb (A) is detected.
NOTE: 1. The existing linked LED bulb may blink. If this occurs, press any button on the remote to stop
the blinking. Then proceed with repeating the linking process.
2. One remote controls up to 20 LED bulbs.
Press and hold the ON/OFF button (BB) and Dimming button (CC) at the same time for 3 seconds.
The indicator light (AA) will begin to ash.
During the linking process, the LED bulb (A) will ash three times. The indicator light on the remote
(B) will remain on for 3 seconds. This indicates that the LED bulb (A) and remote (B)
have been successfully linked.
AA
BB
CC
DD
EE
NOTE: Only one LED Bulb will be unpaired at a time. To unpair all the LED Bulbs simultaneously, reset all
the LED Bulb and remote by following the instructions in the factory default section of the instructions.
To unpair the LED Bulb with the remote, hold down the ON/OFF button (BB) and the CCT tunable
button (DD) at the same time for 3 seconds. The indicator light (AA) will ash as it attempts to detect
the LED Bulb. Once detected, the indicator light (AA) will ash rapidly indicating the unpairing process is
underway. The LED Bulb will blink three times indicating it is unpaired.
To reset the LED Bulb (A), ip the power switch off and on once.
If you want to pair a LED Bulb that was already paired with a remote,
you need to proceed to Step “Unpairing the LED Bulb” with original remote
and then proceed to Step “Touch- Link” to pair it with the preferred
remote.