User Manual

3
US
Do not clean the dehumidier by spraying it or immersing it in water.
Do not insert any object into the opening of the dehumidier.
Disconnect from the mains before cleaning the unit or any of its components.
Never connect to an electrical outlet using an extension cord. If an outlet is not available, one should be
installed by a licensed electrician.
Place the dehumidier in location appropriate to the appliance IP-rating (see technical data).
Any service other than regular cleaning, setting fan mode or lter replacement should be performed by an
authorized service representative. Failure to do so could result in a loss of warranty. Your dehumidier is
supplied with an electrical cable (15 ft) and an earthed plug. Should it be necessary to replace this plug at
any time, you must use an earthed electrical plug.
Warning! Never operate this appliance if it has a damaged cord or plug.
If the supply cord is damaged an approved service representative or a similar qualied person
must replace it in order to avoid any hazards.
There should be direct access to the electrical plug after connecting the power!
Do not use your dehumidier under the following conditions:
• If the power cable is damaged
Where the power cable may be easily damaged
• Close to heat source
Where small children may be left unattended
Where there is a risk of liquids falling on the unit
Where it may be damaged by chemicals
This product is not made for DIY repair.
SAFETY (2) |