Installation guide

11.2- Cost Recovery settings
The following table describes the settings available for the Cost Recovery Service.
11.2.1 - Cost Recovery settings
Setting Description
Configure Cost Recovery service Configures the Cost Recovery Service settings.
Configured Enables all settings for the service.
Port number Enters port number. The port number must match the TCP port configured for
the cost recovery device. The default port is 9325.
Note: If you change the Port field, the Manager is automatically restarted after
saving your settings.
Show Lock Button Shows Lock Button at the client. This button allows you to lock the terminal
from any screen during a session. This option is only available for ScanStation
devices.
Protocols Selects the protocol. This version of the service supports cost recovery
terminals that were configured to work with previous versions of the eCopy
Cost Recovery Service.
l Unicode/XML (v3): Select this option if your terminal is configured to use the
latest version of the Cost Recovery Service (recommended).
l Auto detect (v1, v2): Select this option if your terminal is configured to work
with earlier versions of the Cost Recovery Service.
Note: All devices controlled by a Manager must use the same protocol.
Encryption
Encryption settings must be used if a password is included.
Type The encryption type for Cost Recovery:
l None: Passes credentials to ShareScan without encryption.
l TripleDES: Enables you to encrypt the information from the application that
is supplying the credentials to ShareScan. You can do this by creating an
encryption key that you store on the computer where the Manager is running
and on the Cost Recovery device.
Path Set the path for the encryption key. Specifies a path to the storage destination
for the encryption key on the device where the Manager is running.