Installation guide

10.2- Configuring the service
When you have enabled the service for the system, you can select and enable it for individual connector
profiles, and can create numbering formats that users can select at the device.
To enable the service:
1. In the Administration Console, select the Configure Services tab. The tab displays a list of available
services.
2. Select the service name. The service configuration and the settings pane open.
3. On the configuration pane, select Configuring Service: Bates/Endorsement and then click Save.
The service is configured to use the formats shown in the format list.
Note:
To add more format options, create new formats.
To create a new Bates/Endorsement format:
1. On the configuration pane, click New. A new format is added to the format list with a default name
of New.
2. Select the format and, under Configure Format on the Settings pane, and type a name for the new
format.
3. Use the Settings pane to specify the format settings. As you specify the settings, the Sample
Document area displays the results of the settings as they appear on the page.
4. When the format appears correctly, click Save. The new format is saved with your settings.
Note:
To modify an existing format, select the format in the list, modify the settings, and click Save. The change is that the
settings take effect for all connector profiles that use the format.
10.2.1 - Bates/Endorsement format settings
The following settings are available for the Bates/Endorsement service:
10.2.1.1 - Configure Format Settings
Setting Description
Configure format The Bates/Endorsement format setting.
Format name The Bates/Endorsement format name.
Note: The Bates/Endorsement format name cannot be empty.