Installation guide

9.2- Configuring scanner settings for ScanStation
You can specify scanner settings for devices.
9.2.1 - To specify scanner settings for a device
1. In the Administration Console, select the Devices tab.
2. Select the device that you want to configure.
3. In the Settings pane, select the Scanner tab. The information that you see depends on the device
you are using.
4. Specify the scanner settings in Configuration.
5. Click Save.
9.2.2 - Scanner configuration settings
Settings Description
Driver name Browse and select the driver to be used for scanning. The currently selected driver is
shown.
Click the row and click the right corner to open the Select scanner window. Nuance
Scanner Setup Wizard automatically starts that helps you with scanner configuration.
For more information, see Nuance Scanner Setup Wizard.
Type Type of driver currently selected or in use (TWAIN or ISIS).
Show title bar If a kiosk mode is not desired, setting this value to Yes creates a resizable window with
a title bar.
Password (exit) Prompted when you try to exit the ScanStation Client by pressing the Exit button in
the kiosk mode.
9.3- Setting up scanning devices
Nuance Scanner Setup Wizard is used to configure ScanStation (a ShareScan Client) to communicate with a
scanning device (scanner or network MFP) for the best possible scanning results.
9.3.1 - Scanning device settings
1. In the Administration Console, select Devices > <device name/IP address> > Settings > Scanner.
2. Click the Driver Name row and click the far right corner. The Select Scanner window appears
with the list of all available scanning devices. In some cases, the scanning devices are located
elsewhere in a network. The scanning devices fall into two categories: TWAIN and ISIS.
3. Select the scanning device to be used by ScanStation in the Wizard.