Installation guide

Note:
If there is only one active profile in the All Users group, the My Config button is still visible, even though you cannot
access My Config at runtime.
When you log in for the first time, you are presented with Connectors selected for this department, along
with the My Config button. You can click the My Config button to further select any generally available
Connectors other than the departmental Connectors. Once you select the desired Connectors and click OK,
the Main form is reflected with the changes immediately. At least one Connector profile must be selected for
personalization
Note:
When the user first logs in Departmental Connectors, they always supersede Connectors listed in the All Users group.
In other words, Connectors selected in the Department the user belongs to are displayed on the Main form and the user
can customize Connectors by using My Config, where they are presented with both the Departmental and Connectors
from the All Users group.
8.9.1 - Personalization restrictions
n If the same Connector profile is selected in both the Department and the All Users group, only one
entry or instance of this profile is visible in the list presented in the My Config page (at the Client).
n If the Department does not have any Connectors selected, Connectors form the All Users group and
are displayed by default on the Main Form, along with the personalization button (My Config).
From the main form you can continue with your activity and or log off at any time. The next time you log in,
the Main form is presented with all the buttons configured in the previous login. You can choose to reselect
any of the available Connectors via the My Config button.
If at any point of time you want to remove/modify a generally available Connector profile (from the All
Users group), it is reflected immediately the next time you log into the system. In case of an unselected or
deleted Connector profile, the profile is removed from your personal set of Connectors.
9 - About configuring scanners
When you configure a device, you also specify scanner settings for a device.
Select Devices > <device name/IP address> > Settings > Scanner.
9.1- Specifying default scanner settings
You can specify default scanner settings for devices.
9.1.1 - To specify default scanner settings for a device
1. In the Administration Console, select the Devices tab.
2. Select the device that you want to configure.