Installation guide

7.5.1 - To activate connector profiles
1. In the Administration Console, select the Devices tab. The Device configuration pane displays a
list of the available devices and device groups.
2. Select the device or device group on which you want to activate the connector. The Configure
connectors for device and the Settings panes open. The Configure connectors for device pane
has the following columns:
n Select profiles: Select a default connector from the list.
n Display name: Displays connector's name.
n Configured: Choose Yes or No.
n Layout: Numbers in order of selecting.
3. In the Select profiles column, select the connector profile that you want to activate. You can only
select configured profiles which appear in black. Profiles that are not configured appear in red. Only
the connectors that have valid licenses for the selected device will appear.
4. Click OK and then click Save.
5. Click the Layout button. The Arrange layout window opens with the following settings:
n Connector
n Profile
n Display name
n Order of appearance
6. Drag and drop the profiles to re-arrange the order of appearance of the connector buttons at the client
and click OK.
7. Click Save. The profile is now activated on the device. Note that the web-browser enabled MFP
devices and the simulator there may experience a minor delay (typically less than 30 seconds) until
the new connector settings and connector associations are propagated.
Note:
You can publish connector profiles individually or in groups to one or more eCopy-enabled devices.
7.6- Using connectors
Below, you can find a typical workflow, which provides an overview on how the connectors work.
Depending on the connector, minor details may vary.
At the scanning device, the user follows the standard eCopy workflow to scan and send a document. If you
configure a connector profile to use the Express function, users will not need to perform many of the steps
included in the procedure in this section.