Installation guide

Option Description
Barcode types Specifies the types of the barcodes.
Note:
The types are not fully independent from each other. For example, if the UPC-A barcode type is selected, then the EAN-13
type is also selected automatically. If the EAN-13 type is deselected, then the UPC-A type is also deselected. This behavior
comes from the limitation of the Aspose engine as it does not recognize UPC-A type if EAN-13 is turned off.
The drop-down items checkboxes allow multiple selections (all types supported by Aspose engine are listed ).
Orientation of barcodes Specifies the orientation of barcodes. The following options are available:
l Horizontal
l Vertical
l Horizontal and vertical (default)
Publishing keys You can set as many data publishing keys (maximum is 10) as many barcodes are expected on the page. The associated list
box supplied with in-place editing capability shows the defined keys; the toolbar buttons control adding, editing, and removing
the keys and also changing their order. Renaming the keys is possible by clicking the selected item.
6.4.2 - Barcodes tab settings
Group Setting Description
Layout search order
Layout search order defines the order in which multiple
barcodes in the same zone are indexed. The options are as
follows:
l Top to Bottom
l Left to Right (default)
l Right to Left
Barcode indexing
Delimiter
The delimiter character splits a barcode into multiple
barcodes at each delimiter. This allows more than one
piece of information to be published from one barcode.
Barcode restrictions
Always require checksum Set to always require checksum as barcodes can include a
checksum to help validate the value. In this case, barcodes
without a checksum are ignored.
Length Minimum and maximum length setting filters out bad matches.
Select the following values to:
l Minimum length: Set a minimum length between 2 and 16.
The default value is 4.
l Maximum length: Set a maximum length. The default value is
999.
Note: