Installation guide

Section Field Description
Authentication
Runtime: Prompt
Sender for a user name
and password
Prompts the user at the device to enter a user name and password when the
user presses the Send button on the Send screen.
Available only if SMTP Basic Authentication is enabled on the server.
Note:
If Session Logon is enabled, and SSL is not enabled, eCopy recommends
that you select “None” or “Login as”.
None Use if the SMTP server does not require authentication.
The user at the device is not required to supply any credentials.
If the server requires authentication, the email send process can fail.
Login as Enables the user at the device to connect to the SMTP server without being
prompted for authentication information. The connector uses the user name
and password set by the administrator.
Use Sender’s User ID,
LDAP attribute, and
runtime password
Uses the sender’s LDAP authentication information to connect to the SMTP
server.
To use this option, you must enable the LDAP address book on the LDAP
settings tab.
45 - eCopy Connector for iManage WorkSite
The eCopy Connector for iManage WorkSite allows users to scan documents directly into the WorkSite
library of an iManage WorkSite system from an eCopy-enabled device.
Users can store documents in any eCopy-supported format (PDF, PDF/A, TIF Fax, TIF, JPG, DOC,
DOCX, XPS, XLS and XLSX).
45.1- Configuring the connector
For the generic connector configuration options, click here.
45.2- Defining a scanning destination
For a generic description of defining a scanning destination, click here.
If you select Specify, then you must specify a location, such as a folder or Document Worklist, that can hold
documents.