Installation guide

To configure batch based indexing in Quick Connect:
1. Select the Index file or File name tab.
2. Click New.
The relevant Field editor opens.
3. Enter the Data Publishing name to receive the Published Key from the service. You can specify any
name to the Name field. The Name field provides descriptive information for you.
4. Select Batch-based index value as the Type, and click OK.
5. Follow steps 2 through 4 above for each value that you want to use.
6. Save the connector profile with the values.
When you configure a device and select this connector profile, you must then select the corresponding
Service profile that you set up in the Barcode Recognition Service.
39.1.16 - Quick Connect and Data Publishing
Quick Connect can read data published to a Data Publishing service by a connector. For example, a company
can install a barcode recognition service and then use Quick Connect to access the barcode data that the
service publishes.
The ShareScan administrator is responsible for the following tasks:
n Install and configure the Service on the same PC as the eCopy Manager. For more information see
the Help topic for the Service in question.
n Work with the developer of the service, which may be available from eCopy or from a third party, to
identify the data that the Service publishes and the names of the fields that will contain the published