Installation guide

You must configure the ScanStation Client to use the hard keyboard. This is because the soft keyboard does
not support a third-party fax driver interface.
Before configuring a Fax via Print connector profile, install the fax driver on the ScanStation, or, if supported
by the driver, on a network print server.
The connector supports the following Print/Fax drivers:
n Canon Fax
n RightFax
n Nortel CallPilot Fax
33.1- Configuring the connector
For the generic connector configuration options, click here.
Section/Field Name Description
Print driver A list of the available print drivers that you can use to fax scanned documents.
Authenticate user Specifies the type of user authentication at the device:
l None: The connector will not prompt the user for logon information.
l Novell: The default Novell Netware tree.
l Windows: The default Windows NT domain.
34 - The eCopy Connector for Fax via SMTP
The eCopy Connector for Fax via SMTP enables users to scan and fax documents from an eCopy-enabled
device through an SMTP email-to-fax gateway. To use this connector, you must have a network fax server
and the appropriate SMTP server plug-in.
The scanned document along with the sender and recipient information is sent to the SMTP server as a
MIME-formatted mail message.
The recipient's fax number is included in the To field (on the ShareScan Client) in the format required by the
fax server. The server plug-in recognizes the recipient address as a fax number and hands the request off to
the network fax server for delivery as a fax.
34.1- Configuring the connector
For the generic connector configuration options, click here.