Use and Care Manual

Step G - Sanitize, Test and Purge System

SANITIZE THE SYSTEM

Sanitizing is recommended immediately after installa-

tion of the Reverse Osmosis system. It’s also recom-

mended after servicing inner parts. It is important that

the person installing or servicing the system have

clean hands while handling inner parts of the system.

Complete the following steps to sanitize the system.

See Fig. 25.

1. Make sure that the water supply to the Reverse

Osmosis system is off.

2. Open the Reverse Osmosis faucet. If the tank is

not already empty, allow the water to empty.

3. Locate the eyedropper included in parts bag and

common household bleach (5.25%).

4. Add 3 ml. of bleach into open end of yellow tubing.

Handle bleach according to bleach manufacturer’s

recommendations. See Fig. 25.

5. Connect yellow tubing to tank connector. See Figs.

14 and 25.

6. Sanitizing the system will be completed during the

pressure test and purging steps on the following

page.

NOTE: The bleach must be removed from the

system before drinking the water. See purging

instructions on the next page.

FIG. 25