ADJUSTABLE 2-WAY CROSS BAR RACK REVISED ON 7/14/2016 ITEM#:PS2CBADJ PAGE 1
HANGBAR 1 X FACEOUT 2 X TOP UPRIGHT 2 X SET SCREW 2 X ADJUSTABLE CONNECTOR 2X WRENCH HEX WRENCH BOTTOM UPRIGHT 2 X BASE 1 X CASTER 4 X INCLUDED PARTS AND TOOLS PAGE 2
1 1 SCREW THE CASTERS INTO THE BASE AS SHOWN USING WRENCH PAGE 3
2A 2 2 2A BY HAND, SCREW IN BOTTOM UPRIGHTS AS SHOWN TO FULLY TIGHTEN UPRIGHT, PLACE INCLUDED WRENCH INTO PIPE SLOTS AS SHOWN. TIGHTEN FULLY.
3 3 4 BY HAND, SCREW ADJUSTABLE CONNECTORS TO BOTTOM UPRIGHTS SUFFICIENTLY & THEN ADJUST SO THAT IT ALIGNS AS SHOWN BELOW TIGHTEN THE SET SCREW USING HEX WRENCH TO LOCK ADJUSTABLE CONNECTOR IN PLACE.
5 5 BY HAND, SCREW IN TOP UPRIGHTS TO HANGBAR AS SHOWN PAGE 6
HAND WHEEL 6 6 (UNTIGHTEN HAND WHEEL) DROP HANGBAR ASSEMBLY FROM STEP 7 AS SHOWN AT DESIRED HEIGHT & LOCK IN POSITION BY TIGHTENING THE HAND WHEEL.
7 7 SCREW IN FACEOUTS TO HANGBAR PAGE 8
