Quick Start Guide

Replacing/Installing Battery:
Counter Clockwise with a small twist open the EZW1204 to expose circuit board, LED, and battery holder.
Install the 1 x 23A battery. Replace the cover with a small clockwise twist to snap it into place.
Pairing the ELS100 Leak Sensor with the Bulldog-JW Control Module:
Including or Pairing the ELS100 to the Bulldog-JW Controller: Multiple Leak Sensors can be paired/included into the 433MHz wireless
network, one at a time, in a simple 3 step process:
1. Put the Bulldog-JW Controller into pairing mode (single button click, see Bulldog-JW Quick Start Guide)
2. Activate the Leak Sensor by getting it wet for 2 seconds (wet paper towel or cloth)
3. Test in location by getting leak sensor wet and confirming Control Module Relay Activation/Valve Close
Leak Sensors can not be excluded (un-paired) individually. All leak sensors will be excluded from the Control Module when exclusion process
is initiated. (see Bulldog-JW Control Module Leak Sensor Exclusion Process – hold pairing button for 5+ seconds)