User Start Guide

EVC200 Z-Wave Plus Commands:
Z-Wave Network inclusion
Putting your controller into inclusion mode (adding new devices). Press
the Power button 3 or more times rapidly (within 1.5 seconds). It is
recommended to keep the EVC200 within 1M/3ft of the controller. (Set
controller to inclusion mode first)
While waiting for inclusion/adding commands from controller, LED
blinks 1 time per second. If after 30 seconds device is still not included
(timeout), LED will blink rapidly for 1 seconds signaling an
including/adding error.
Z-Wave Network exclusion
Power the button 3 or more times rapidly (within 1.5 seconds). It is
recommended to keep the EVC200 within 1M/3ft of the controller. (Set
controller to inclusion mode first)
While waiting for inclusion/adding commands from controller, LED
blinks 1 time per second. If after 30 seconds device is still not included
(timeout), LED will blink rapidly for 1 seconds signaling the
including/adding error.
Device Reset
Press and hold the Power button for 10 seconds. The device will send
the reset notification to the list node in the group-1 and erases the
device memory. The led light flashes acknowledging successful reset.
Note: This should only be used in the event your networks primary
controller is missing or otherwise inoperable
Association capabilities
This device supports only the Lifeline Association Group which holds a
maximum of 1 node ID. The only command sent to this group is the
Device Reset Locally message.
This device cannot be used to control other devices by association. The
pushbutton only opens and closes the water valve connected to it.
Z-Wave Command Class
COMMAND_CLASS_ZWAVEPLUS_INFO,
COMMAND_CLASS_SWITCH_BINARY,
COMMAND_CLASS_ASSOCIATION,
COMMAND_CLASS_ASSOCIATION_GRP_INFO,
COMMAND_CLASS_VERSION,
COMMAND_CLASS_MANUFACTURER_SPECIFIC,
COMMAND_CLASS_DEVICE_RESET_LOCALLY,
COMMAND_CLASS_POWERLEVEL
If you have any questions or if you are experiencing any issues with the EVC200,
please contact EcoNet Controls Support via email at [e-mail] or by phone at 888-320-9188.
For more details, please visit www.EcoNetControls.com.