Use and Care Manual

7
ENGLISH
WARNING: Do not remove filter cage and float.
The float prevents water from entering the impeller
and damaging the motor. The cage
prevents fingers
from touching the moving impeller.
CAUTION: Clean the filter in an open area.
CAUTION: After cleaning, check the filter for
tears or small holes. Do not use a filter with holes
or tears in it. Even a small hole can cause dust to
come out of the vacuum. Replace it immediately.
CAUTION: If the filter is clean and not damaged,
replace it on the filter cage. If it cannot be reused,
place a new filter over the filter cage.
CAUTION: To avoid damage to the impeller and
motor, always reinstall the reusable filter before
using the vacuum for dry pickups and always
reinstall the foam filter before using the vacuum for
dry pickups and wet pickups.
Before storing the vacuum, the dust tank should be
emptied and cleaned. The cord should be wrapped
and hung on the unit and the accessories should be
kept in the accessory holder. The vacuum should be
stored indoors.
STORAGE
Minor problems often can be fixed without calling
customer service.
TROUBLESHOOTING
Vacuum does
not run
Loss of
suction, wet
pick-up
Loss of
suction, dry
pick-up
No electricity
1. Full tank
2. Clogged hose
3. Clogged filter
1. Drain and clean tank
2. Remove hose and
clean debris
3.
Clean or replace filter
Make sure electrical
outlet has voltage (A
qualified electrician may
need to be contacted)
1. Full tank
2. Clogged hose
3. Clogged filter
1. Drain and clean tank
2. Remove hose and
clean debris
3.
Clean or replace filter
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
WARNING: TO REDUCE THE RISK OF INJURY
FROM MOVING PARTS AND/OR ELECTRICAL SHOCK,
TURN POWER SWITCH OFF AND DISCONNECT
GROUNDED PLUG FROM ELECTRICAL OUTLET
BEFORE PERFORMING TROUBLESHOOTING CHECKS.
WARNING: To reduce the risk of injury from
accidental starting, unplug power cord before
changing or cleaning filter. The filter should be
cleaned frequently to maintain peak vacuum
performance.
MAINTENANCE