Product Manual

ManualsBrandsEcoMaster ManualsAutomotive45-Gallon Aqueous Industrial Parts Washer

04379 Page 10 11-01-12

ECN 3783

VII. TROUBLESHOOTING

A. Machine does not operate:

1. Make sure the parts cleaner is connected to electric power or air supply.

2. Check for incoming power. Check serial plate for power requirements.

3. On electric units: check reset button on GFCI cord to make sure it is not tripped. On air units: an

increase in air supply may be required.

B. Cleaning fluid not to temperature:

1. Check to make sure heater switch is turned “ON”.

2. Check fluid level in tank.

3. Check to see if high temperature reset is tripped.

C. Little or no fluid flow thru the flow-thru brush:

1. Turn pump switch “ON” or increase air pressure.

2. Check the fluid level in the tank.

3. Check pump intake for obstructions.

MACHINE NOT

FUNCTIONING

PROPERLY

WHAT DOES

NOT WORK?

IS THE

SWITCH ON?

PUMP

IS THE FLUID LEVEL

HIGH ENOUGH TO

SUBMERGE THE

PUMP?

YES

TURN ON THE

SWITCH

ADD FLUID

IS THE FILTER

SCREEN ON THE

PUMP CLOGGED?

YES

CLEAR THE

SCREEN

YES

ARE THE

SWITCHES

ON?

PUMP

HEATE

TURN ON THE

SWITCHES

IS THE MACHINE

PLUGGED IN TO A

GROUNDED

OUTLET?

YES

PLUG IN THE

MACHINE

IS THERE

POWER TO THE

RECEPTACLE?

YES

APPLY POWER AND

RESET GFCI CORD

IS THE RESET ON

THE GFCI CORD

TRIPPED?

YES

PRESS THE RESET

BUTTON ON THE GFCI

CORD

YES

REPLACE THE

GFCI CORD

IS THE FLUID

TEMPERATURE

ABOVE 120 OR

BELOW 100?

HEATE

REPLACE THE

THERMOSTAT

ABOVE

IS THE HEATER

SWITCH ON?

BELOW

TURN ON THE

SWITCH

IS THE HIGH

TEMPERATURE

RESET TRIPPED?

YES

WAS THE FLUID

OVER 120 DEGREES

AT ONE TIME

YES

PRESS THE HIGH

TEMPERATURE

RESET BUTTON

ARE ALL THE

WIRES IN THE

CONTROL BOX

HOOKED UP?

PLUG IN THE

WIRES

REPLACE THE

HEATER

YES

ARE THE VALVES

FOR THE BRUSH

AND SPIGOT OPEN?

OPEN THE

VALVES

CHANGE THE

PUMP

YES