Operation Manual

15
Getting Started with XP5560 BOLT IS (ECOM Ex-Handy 08 or Ex-HSPA 08)
3 Insert Battery
Insert the battery and ush into
the battery slot such that the
three metallic contacts at the top
of the battery are aligned with
the metallic contacts within the
battery compartment.
4 Close Cover
Close the battery cover. Rotate the battery
cover screws in clockwise direction. You
can use the screwdriver provided to tighten
the screws. Ensure not to overtighten the
screws.
Removing the Battery (Zone 1 models)
To open the IS battery, rotate both the IS battery screws
in an counter clockwise direction. Sometimes, the battery
cover may be tight and some extra effort is required to
open it. You can use the screwdriver provided to open the
screws.
Removing the Battery (Zone 2 models)
Follow steps 1 and 2 of “Inserting the Battery (Zone 1
models)” on page 14 and “Inserting the Battery (Zone 2
models)” on page 14..
To remove the battery, lift the cover behind the phone and
raise the upper end of the battery from the slot. Follow
step 4 of “Inserting the Battery (Zone 1 models)” on page
14 and “Inserting the Battery (Zone 2 models)” on page 14. to
close the cover.
WARNING
DO NOT remove or install your battery in your Sonim
XP5560 BOLT IS (ECOM Ex-Handy 08 or Ex-HSPA 08)
in a hazardous environment.
Charging the Battery
The battery delivered with your mobile phone is not fully
charged. We recommend that you charge your mobile for
5 hours before you use your mobile phone for the rst
time.
WARNING
DO NOT charge your Sonim XP5560 BOLT IS (ECOM
Ex-Handy 08 or Ex-HSPA 08) inside hazardous areas
and/or with anything other than the provided Safety
Box “SBH 07” (USB Cable)
Charging your Sonim XP5560 BOLT IS (ECOM Ex-
Handy 08 or Ex-HSPA 08) with a different cable/
charger and/or in a hazardous environment will
compromise the Intrinsically Safe nature of the
device.
There is a risk of explosion while charging if the
battery has been replaced by an incorrect type.