Operation Manual

Chapter 3 — About the Scanner
39
About the Wedge Mode Profile
Wedge mode enables a default list of symbologies (for example, UPCA,
Code 39, Code 128, GS1128, Aztec, Data Matrix, Maxicode, Pdf417 and
QR code). You can enable or disable Symbologies for wedge mode
using a profile named HONWedge. Profile commands customize scan
wedge mode behaviors. Customers set wedge mode configuration
commands using an .exm file. To learn more about customized profiles,
see the next section “Create a Custom Profile” on page 41
.
You can use the following HONWedge profile commands to modify the
scan wedge.
HON:EnablePreviewOnDecodeAttempt Profile not supported in ScanDemoW10.
HON:DisablePreview The default profile. Disables sending images to
the application. Only decode results are shown on
the screen.
HON:EnableOOBE
Enables the symbology types required when the
built-in Out-of-box plug-in runs at first boot for
s
canning EZConfig labels. This profile allows you
to sc
an a prov.xml file to set up the CT50 -Ex.
You cannot modify this profile.
HON:ScanButtonEnable Enables the Scan button.
HON:ScanButtonDisable Disables the scan button.
Profile Settings and Descriptions (continued)
Profile Description
HONWedge Profile Commands
Profile Commands Description Default
ENABLE_WEDGE Controls when bar code data is inserted into
the keyboard buffer.
While in wedge mode, scanning is disabled
and enabled using the ENABLE_WEDGE
profile command.
Tr u e
(Enabled)