User's Manual
Datum // date
10.07.2014
Teile-Nr. // part no.
300011
Dokument-Nr. Revision //
document no. revision
300011AL11E 07
Head Module Settings
User Manual
Seite/gesamt // page/total
6 / 25
Dokument erstellt // document created
SAS387 10.07.2014
Dokument geprüft // document checked
FIH091 10.07.2014
User Manual: Head Module Settings
● Ablageort: C:\Users\de0216\Documents\Quellcode\EcomService\user_manual_head_module_settings\300011AL11E07_user_manual_head_module_settings.docx
● template no.: 0730QV06A03 ● template created: HAO006 20.01.2011 ● template checked: BEA373 20.01.2011 ● location: ISO drive ●
timeout for reading (in seconds)
Timeout for reading a TAG (a value from 1 to 25 seconds is
allowed).
Output Data
Format of the output data (HEX or ASCII).
1.5 #H – UNI13 (high frequency RFID reader)
To make some changes for the HF reader, enable the reader in the “Enable Module” section in the Head
Module Settings. Then click on “Setting #H – UNI13” (see Pic6). In the next window (see Pic7) make
your changes you want to do for the HF reader and save them by clicking the OK button.
Pic6: Head Module Settings after
enabling the HF reader Pic7: HF reader settings
Explanation of the settings for the #H – UNI13:
Setting
Description
COM Port
Serial port of the reader.
set UID in front
Enable or disable that the UID of a TAG should be put in front of the
read data.
Note: When this option is enabled and “data length” is set higher
than 0 and reading of data from a TAG failed, the UID of the TAG
will be output alone.
from block
Start block address to start reading a TAG.
data length
Length of data to read from a TAG.
ISO 15693
Enable or disable ISO 15693 transponders.
ARIO 64bit
Enable or disable ARIO 64bit system.
ICODE UID
Enable or disable ICODE UID system.
ICODE 1
Enable or disable ICODE 1 transponders.
Mifare
Enable or disable Mifare transponders.
Pico-Tag
Enable or disable Pico-Tag transponders.
timeout for reading (in seconds)
Timeout for reading a TAG (a value from 1 to 25 seconds is
allowed).
Output Data
Format of the output data (HEX or ASCII).
change high byte with low byte
Enable or disable the changing from high byte with low byte of the
output data.