User's Manual

8 9
About Language Provisioning
If your i.roc® Ci70 -Ex computer includes language provisioning, you are prompted to select a
language provision when the computer starts for the rst time. It may take up to 15 minutes to load
your language.
Make sure you select the correct language before you tap Provision. If you need to have the lan-
guage provisioning changed, you will need to send your computer to an ecom instruments Global
Repair Center.
About the Battery L
The computer uses following rechargeable Lithium-ion battery pack as the main power source:
• 3.7 V, 4000 mAH (14.8 Wh) battery AM Ci70 -Ex
L
The battery used in this device may present a fire or chemical burn hazard if it is mistreated�
Do not disassemble it, heat it above 60 °C (140 °F) or incinerate it� Dispose of used batteries
promptly� Keep away from children�
Charge the Battery
You need to fully charge the battery before using your computer for the rst time.
Change the Battery
If your battery power is low, you need to either charge the battery in the computer, or replace it
with a charged battery.
1 Save your les and close any open applications.
2 Press the Power button and choose Shutdown from the menu to shut down the computer.
3 Detach the handstrap from the computer.
Detaching the Handstrap from on i�roc
®
Ci70 -Ex
4 Make sure the computer is in hibernate mode and that the screen has turned off.
5 Remove the battery.
Unscrew the battery‘s screw using enclosed screwdriver. Lift lower part of the battery to
release it from the computer.
About the Status LEDs
Use the following illustrations and table to understand the status LEDs on your computer. All six
status LEDS are not available on every i.roc
®
Ci70 -Ex computer. For example, the QWERTY ver-
sions of the i.roc
®
Ci70 -Ex do not have a Green key status LED.
Location of the i�roc
®
Ci70 -Ex Status LEDs
Green key
status LED
Shift key
status LED
Orange key
status LED
Battery status LED
Notication LED
Good Read and Ready-to-Work
Status LED
Status LED Descriptions
LED Color Description
Notication Amber This LED is user-programmable
Good Read Green The computer successfully decoded a bar code.
Ready-to-Work Blue If you have Intermec Terminal Emulator (ITE), the application is
running and connected to the host.
If you do not have ITE, you can congure the Ready-to-Work indi-
cator to turn on or off to indicate a healthy state.
Blinking
blue
ITE is running but not connected to the host.
The computer is unhealthy.
Off ITE is not installed or not running.
The computer is healthy.
Battery See “About Battery Status” on page 13.
Key Status Green The Green function key is enabled.
Orange The Orange function key is enabled.
Shift Red The Shift key is enabled.