User Manual

PROGRAMING TIMERS FOR USE WITH SUNSET
EXAMPLE SCENARIOS:
Ex. #1 Want the SunSet
tm
to turn on at sunset and the lights off at sunrise
– No need to set timers, just learn the SunSet
tm
to the Zone Control
Ex. #2 Want SunSet
tm
to turn the lights on and the timer to turn the lights off
On time – Sunset (6:30pm)
Off time – Zone 1 & 2 – 10:00pm, Zone 3 –11:30pm
Programming Notes:
- Both an on and an off time must be set for each zone that is enabled
- The on timer should be set after sunset and before the timer turns the lights off
- The off timers can vary.
Read for further explanation:
The SunSet
tm
will be turning the lights on at sunset and the timer will be turning the lights off at a user defined time. In this
example the sun sets at 6:30pm, at that time the lights will turn on. The on timer is set for 8:00pm, the lights remain on. The
customer wants Zones 1 and 2 to turn off at 10:00pm and Zone 3 to turn off at 11:30pm, the off timer in Zones 1 and 2 is set for
10:00pm, and the off time for Zone 3 is set for 11:30pm. It’s that simple.
Technical support
Toll-free: [phone] in the US, including Alaska and Hawaii; Puerto Rico; Canada.
Outside the toll-free area: Contact your local dealer.
FCC compliance
This device complies with part 15 of the FCC rules. Operation is subject to the following conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority
to operate the equipment.
Sunset
Zone 3
OFF
Timer
Zone 1 & 2
OFF Timer
On Timer
Zone 1
Zone 2
Zone 3
6:30pm
8:00pm
10:00pm
11:30pm