User's Manual

© 2017 Ecolink Intelligent Technology Inc. PN TLS-ZWAVE5 R2
LED Status
The Z-Wave Plus Toggle Light Switch is equipped with a red LED. The state of the LED will change based on the state of the device.
LED Blinking - Device not included into a network.
LED On - Device In Learn mode.
LED blink - Device in lower power mode. Remote control disabled.
Battery State
The Z-Wave Plus Toggle Light Switch will alert the user when the batteries become low. While the batteries are low, the user will be unable to change
the light state remotely. The Z-Wave Plus toggle Light Switch will continue reporting the state of the switch until the batteries are completely depleted.
Factory Default
The Z-Wave Plus device is automatically factory defaulted when removed from a Z-Wave Plus network. Please use this procedure only when the network
primary controller is missing or otherwise inoperable.
Inclusion / Exclusion button
Figure 1
Installation
The package contains the following:
 Ecolink Z-Wave Plus Toggle Light Switch
 Screw for the Z-Wave Plus Toggle Light Switch
 2 AA batteries