Installation Guide
Table Of Contents
- Product Overview
- Features
- Specifications
- Package contents
- Installation Instructions
- Network Inclusion
- Network Exclusion
- Z-Wave Plus Specific Information Z-Wave Plus is a wireless mesh network and data protocol that allows devices from many different manufacturers to interoperate. This device implements Z-Wave Plus functionality, Network Wide Inclusion. The following in...
© 2019 Ecolink Intelligent Technology Inc. PN TILT-ZWAVE5
Network Exclusion
1) Any Z-Wave Plus Device can be removed from any Z-Wave Plus
controller. Follow the directions to put your Z-Wave Plus
Controller into exclusion mode.
2) Press the inclusion / exclusion button on the Z-Wave Plus Tilt
Sensor.
3) The LED in front of the unit will blink steadily if the network
exclusion is successful.
*Please refer to the LED status section for more information on the
LED behavior
Notes:
• Controller inclusion mode must be activated BEFORE starting
sensor inclusion or exclusion mode.
• The device can only be included into one controller network at
a time, and must be excluded from one network before
inclusion in another.
LED Status
The Z-Wave Plus Tilt Sensor is equipped with a red LED.
The state of the LED will change based on the state of the device.
LED Blinking - Device in learn mode
LED On - Device OTA (over the air) Update
LED blink - Tilt Detected/Restore, Tamper Detected/Restore
Battery State
The Z-Wave Plus Tilt Sensor will alert the user when the batteries
become low. The Z-Wave Plus Tilt Sensor will continue reporting the
state of the sensor until the batteries are completely depleted.
Factory Default
The Z-Wave Plus Tilt Sensor can be factory defaulted by pressing and
holding the factory reset button for 5 seconds.
Factory Reset Button
Learn Button
(Inclusion/Exclusion)