Installation Guide

© 2019 Ecolink Intelligent Technology Inc. PN TILT-ZWAVE5
(2) Mount the Tilt sensor mounting bracket a clean dry surface with the
sensor screw facing the floor. The bracket can be mounted by the
screws of adhesive tape. Caution: Use of the screws is only
recommended for garage doors that are thicker than the screws are
long. Use the adhesive tape for any garage door that is thinner than
the length of the provided screws.
(3) Adhesive Tape Mounting: Make sure that the desired mounting
location on the door is clean and dry. The adhesive tape can
withstand the temperature and humidity conditions of a typical
garage. However, it is recommended that the sensor be mounted
when air or surface temperatures are not extreme. Installing the
adhesive tape when the conditions are right promotes a good long-
lasting adhesive bond between the bracket and the surface of the
door. Peel back the outer layer of one side of the adhesive tape,
stick the tape to the garage door and press firmly. Peel back the
outer layer on the other side of the tape and press the mounting
bracket firmly onto the adhesive tape.
(4) Screws Mounting: Place the mounting bracket in the desired
position on the garage door. Use the mounting bracket as a
template to mark the location of the screw holes with a pencil. Drill
a small hole through each of the marked locations. Use a
screwdriver to fasten the mounting bracket to the door.
(5) Install 1x CR123A batteries provided in the package.
(6) Before the sensor is secured to the mounting bracket. Follow the
inclusion instructions to verify successful communication with the Z-
Wave Controller.Follow the Network Inclusion steps in next section.
(7) After network inclusion, secure the sensor onto the mounting
bracket with the sensor screw.
(8) Test the connection by opening and closing your garage and
observing the open and close statuses.
Network Inclusion
The Z-Wave Plus Garage Tilt Sensor must be added to a Z-Wave Plus
network prior to use. To include the device in a network both the
device and the network controller must be in inclusion mode at the
same time. Refer to the instructions provided by the manufacturer of
your specific controller for details on initiating the controller’s
inclusion mode.
1) Verify that the Z-Wave Plus controller you are using is compatible
with the Z-Wave Plus Tilt Sensor.
2) Put your Z-Wave Plus Controller into add (inclusion) mode.
3) Insert the battery and press the learn button on the tilt sensor.
4) The LED on the front of the unit will turn off if network inclusion is
successful.
Adhesive Tape
Mounting Bracket
Bracket
Screws
(optional)
Sensor
Sensor
Screw