Installation Guide
Table Of Contents
- Product Overview
- Features
- Specifications
- Package contents
- Installation Instructions
- Network Inclusion
- Network Exclusion
- Z-Wave Plus Specific Information Z-Wave Plus is a wireless mesh network and data protocol that allows devices from many different manufacturers to interoperate. This device implements Z-Wave Plus functionality, Network Wide Inclusion. The following in...
© 2019 Ecolink Intelligent Technology Inc. PN TILT-ZWAVE5
Product Overview
The accelerometer based tilt sensor remotely monitors garages, hatches,
roll-up doors, or any other tilt surface. Verify doors are closed when you
leave, and automate lights to turn on inside your home when you arrive, all
from your computer, tablet or smart phone.
Features
• Quick installation, flush mount bracket with screws or tape
• Compatible with all Z-wave certified hubs & controllers
• Detects angle of a door and transmits open/close status
• Reports a tamper if the case is removed
Specifications
• For indoor use only
• Operating frequency: 908.42, 916 MHz
• Operating temperature: 0° – 49°C, 32° – 120°F
• Operating humidity 5-95% non-condensing
• 1 CR123A battery
• Battery Life: 5 years
Package contents
• 1 x Z-Wave Tilt Sensor
• 1 x CR123A batteries
• 1 x Installation Guide
• 1x Accessory Pack
o 1x Mounting Bracket
o 1x Double Sided Adhesive Tape
o 2x Mounting Screws
o 1x Mounting Bracket Screw
Installation Instructions
(1) Identify location for Z-Wave Plus Tilt Sensor. It is very important
that the Tilt sensor be located on the top section of a multi-panel
garage door. This will be the first section to tilt when the door is
opened and the last to move to the vertical position when closing.
IMPORTANT: The Tilt sensor must be located on the top panel AND have the arrow on
the side of the sensor pointing UP in order to operate properly.