User's Manual

© 2017 Ecolink Intelligent Technology Inc. PN SDLS2-ZWAVE5 R1
LED Status
The Z-Wave Plus Smart Switch is equipped with a red LED. The state of the LED will change based on the state of the device.
LED Blinking - Device not included into a network.
LED On - Device In Learn mode.
LED blink - Device in lower power mode. Remote control disabled.
Battery State
The Z-Wave Plus Smart Switch will alert the user when the batteries become low. While the batteries are low, the user will be unable to change the light
state remotely. The Z-Wave Plus Smart Switch will continue reporting the state of the switch until the batteries are completely depleted.
Factory Default
The Z-Wave Plus device is automatically factory defaulted when removed from a Z-Wave Plus network. Please use this procedure only when the network
primary controller is missing or otherwise inoperable.
Inclusion / Exclusion button
Figure 1
Installation
The package contains the following:
 Z-Wave Plus Smart Switch – Single Rocker
 2 AA batteries