User's Manual

2 MODEL XXXX FLAT PIR
2. SPECIFICATIONS
Two - Dual element low-noise pyroelectric sensor
18 parabolic mirrors for long range
18 parabolic mirrors for close range
15 x 15 m, (49.2 x 49.2 ft) / 90°
Up to 38 kg (85 lb)
ELECTRICAL
Two 3V Lithium batteries, type CR-123A. For UL installations, use Panasonic only
1400 mAh per battery
Typically over 5 years
Note: Inability to connect with wireless network, or wireless link quality no higher than 20% may
significantly reduce the expected battery life.
Performed immediately upon battery insertion and during each transmission to the panel
FUNCTIONAL
3 seconds
Red LED lights for about 3 seconds upon transmission of alarm & tamper messages and upon motion
detection in the walk test mode only.
Red LED flashes during the power-up stabilization period, or after restoring (pressing) the tamper switch.
Red LED does not light upon transmissions of supervision messages or alarm detection after termination
of walk test mode.
After an alarm, the detector will go into low power mode and not check for motion for 3 minutes. After 3
minutes the detector will check for motion. If there is still motion, it will NOT transmit. If after 3 minutes
there is no motion it will transmit to the panel. Timer disabled in the walk test mode
WIRELESS
ZigBee H.A 1.2
2.405 2.480 Ghz as per IEEE 802.15.4
Reported when a tamper event occurs and in any subsequent message, until the tamper switch is
restored
Signaling at 5 minute intervals
Signaling at 27 minute intervals
MOUNTING
2.9 m (7.5 ft).
Surface or corner
ENVIRONMENTAL
>20 V/m up to 1000 MHz
-10°C to 50°C (14°F to 122°F
-20°C to 60°C (-4°F to 140°F)
COMPLIANCE WITH STANDARDS
CFR 47 part 15
ANSI/UL 639
PHYSICAL
83 x 61 x 42 mm (3.27 x 2.4 x 1.66”)
90 g (3.17 oz)
White