User's Manual

© 2015 Ecolink Intelligent Technology Inc. PN PIR-ZWAVE2 R1.03
What is Z-Wave?
The Z-Wave protocol is an interoperable, wireless, RF-based communications technology designed specifically for control, monitoring and status reading
applications in residential and light commercial environments. Mature, proven and broadly deployed (with over 35 million products sold worldwide), Z-Wave is
by far the world market leader in wireless control, bringing affordable, reliable and easy-to-use 'smart' products to many millions of people in every aspect of
daily life. Certified Z-Wave devices regardless of manufacturer can work together to form a Z-Wave mesh network. Always on Z-Wave devices can act as
repeaters in the mesh increasing range and redundancy.
For a more complete look at Z-Wave technology for non-technologists, and to learn more about Z-Wave's role as a key enabling technology for the Internet of
Things and connected objects, please visit www.z-wave.com.
Test Mode
The amount of time it takes for the sensor to reset after motion has been detected
can be shortened for quicker motion sensor testing. To enter test mode remove the
cover from the sensor. Find the pair of metal pins on the lower right hand side of the
circuit board labeled “TEST”. Connect these two pins together using the provided
jumper. Replace the sensor cover. After approximately ten seconds the red LED
will go out. The sensor is now in test mode. In test mode the LED will flash once
when motion is detected and again when motion detector is ready again. In this
mode you can wave your hand in front of the sensor or walk around the room and
see where motion is detected. Note that there must be a length of time without
motion before motion detect is enabled again. To restore normal operation simply
remove the test jumper and replace the sensor cover.