User's Manual

ManualsBrandsEcolink Intelligent Technology ManualsElectronicsHome Motion Sensor

ADDITIONAL NOTES AND SUMMARY:

 BEFORE attaching the bracket to a surface note how the bracket will need to be oriented in order for the tab to engage the sensor. The required orientation of the

sensor determines the bracket orientation. The large clip that holds the case together is located on the TOP. Please be advised that adhesive tape may damage the

surfaces to which it is attached and then removed from.

 The sensor slides onto the bracket until the tab engages and CLICKS.

 The distribution pattern of the motion detector is approximately +/- 50 degrees left and right of center, and at maximum sensitivity will reach a maximum of

approximately 45 feet. See example distribution pattern below.

Adjusting the Sensitivity of the Motion Sensor

The motion sensor has sensitivity adjustment via jumper placement on

a pair of pins on the circuit board of the sensor. Refer to the battery

replacement section to open the case and find the jumper pins inside

the case.

Motion Detector Distribution Pattern