User's Manual

6. The sensor enters sleep mode when not in use. However, the sensor must be “awake” to receive
messages from the controller. To activate “stay-awake mode”, remove the front cover. This will wake
up the sensor. Leave the cover off to enable the controller to query the sensor for device specific
information and capabilities.
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired
operation.
Changes or modifications not expressly approved by Ecolink Intelligent Technology, Inc. can void the
users’ authority to operate the equipment.
Federal Communications Commission Statement