User's Manual

8 | P a g e
6. Application-Level Retries
Description
Number of attempts on top of the stack-level retries to try to reach the
controller/hub with Z-Wave messages.
Size
1
Format
Unsigned Integer
Read only
No
Min Value
0
Max Value
10
Default Value
3
Indicator
Indicator
ID
Name
Binary
Level
Time
Out
Seconds
On-Off
Period
One
Time
On-Off
Period
On-Off
Cycles
0x50
Identify
0x02
0x01
0x07
0x03
0x05
0x04
The indicators supporting properties On-Off Period, One Time On-Off Period, and On-Off Cycles can safely
interrupt the other indicators, and the other indicators if active will resume.
The Identify indicator flashes the device’s status indicator.
Multilevel Sensor
The temperature is reported through the Multilevel Sensor Command Class. The temperature sensor is polled
every 30 seconds and any change in temperature will send a Multilevel Sensor Report. A Multilevel Sensor
Report will also be sent if the temperature has not changed in the past hour. Temperature is reported in
Celsius with a precision of one (e.g. a decimal value of 212 would be equivalent to 21.2 °C).
Notification
The following Notifications are supported and sent to the Lifeline Association Group.
Type
Event
Access Control (0x06)
Window/door is open (0x16)
Window/door is closed (0x17)
Barrier motor has exceeded manufacturer’s operational time limit
(0x42)
Barrier unable to perform requested operation due to UL requirements
(0x44)
Barrier sensor not detected / supervisory error (0x49)
Barrier sensor low battery warning (0x4A)
System (0x09)
Tampering, product cover removed (0x06)
Supervision
When included with S2, all unsolicited Z-Wave messages from the device to the Z-Wave controller are
encapsulated in a Supervision Get command to ensure proper decoding, so the device must see both an ACK
and a corresponding Supervision Report to consider the message communicated successfully.