User's Manual

LED
The Flood Sensor is equipped with an LED. On power up, the LED will stay solid for 2 seconds, then blink 3 times every
5 seconds (approx.) when not enrolled with a panel. If the sensor is already enrolled into a network, it will illuminate
the LED for approximately 4 seconds and then turn off.
REPLACING THE BATTERY
When the battery is low a signal will be sent to the control panel. To replace the battery:
1) Remove the Flood Sensor from installation location by removing protective cover if necessary.
2) Pry the cover open using the notched areas on either side.
3) Replace the two AAAA 1.5Vdc batteries ensuring the + side of the battery faces as indicated on the device.
4) Re-attach the cover, you should hear a solid snap when cover engages properly.
5) Replace the protective plate if necessary.
REBOOTING AND RESETTING TO FACTORY DEFAULTS
In order to reboot the device, simply remove the battery and place it back in. Upon doing this, you should see the LED
illuminate. See LED section for more information on LED behavior.
To reset the device to factory defaults use the following instructions:
1. Open case and remove battery from device.
2. Press and hold tamper switch.
3. Place battery back into the device while still holding the tamper switch.
4. When you see the LED illuminate, release the tamper switch.
5. After releasing the switch, the device will restore to factory defaults and the LED should begin blinking again.
PACKAGE CONTENTS
Included Items:
1 x FLZB1-ECO Flood Sensor
1 x Protective Plate
2 x Mounting Screws
2 x AAAA batteries
1 x Installation Manual
Non-Included Items:
Security Control panel
FCC COMPLIANCE STATEMENT
This equipment has been tested and found to comply with the limits for Class B digital devices, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction manual, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
• Re-orient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment to an outlet on a different circuit from the receiver
• Consult the dealer or an experienced radio/TV contractor for help.
WARNING: Changes or modifications not expressly approved by Ecolink Intelligent Technology Inc could void the
user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.